Grit 5000 Wet And Dry Sandpaper P5000 Waterproof Sanding Sheet Sand Paper

Product Information

Line a portion of the work surface with foam rubber and place a float glass over it. You can use any piece of glassware you don’t need as the float glass. You’ll grind the edge you’d like to work on against the float glass, while the foam rubber is useful for keeping the glass in place. It's often thought that the grit number refers to the number of grit particles per square inch. Not so. Rather, the number scale refers to the number of holes per square inch in the screens that are used when sieving the abrasive grains during the sandpaper's manufacture. For example, in 60-grit sandpaper, the abrasive particles used in the paper were sieved through a screen that had 60 holes per square inch. How Sandpaper Grit Works Sand the area you’ve outlined with the marker, using short strokes. Avoid leaving any spots untouched. Remove all the clear areas within the section you’ve outlined, and don’t use the tool on the masked parts. The tape will only offer some protection, but it won’t hold up well against persistent bumps.

An alternative to diamond sandpaper is silicon carbide sandpaper. Options likely found in your local hardware store, such as garnet or aluminum oxide sandpaper, should not be used. Very pleased with this paper,it retains its form well and the grit seems to keep sharp without clogging. During the process, you’ll also need to keep the sandpaper wet to avoid getting a lot of glass dust in the air. Additionally, you’ll require a dust mask, safety glasses, and a pair of gloves for personal protection.Hold the glass down with your hand, protected by safety gloves and goggles. For glass pieces with multiple edges, hold them in a way to avoid cuts and piercings. (If this is not possible, explore other options for securing the glass before starting the next step.) You can sand glass to make it smaller. It is a lot of work, but you can do it (source: WoodWorking Talk). Some people go straight to cutting off part of the glass to save time and energy, but there are some scenarios where sanding the glass will deliver a better finish overall. Some people keep the surface and sanding pad wet by working under running water (source: Glass Etching Secrets). Cover up areas you don’t want the frosted effect on with a coat of painter’s or masking tape. Use small tape pieces cut into the right shape when covering up tight corners and curved edges.

Set the tool to a medium speed level. The exact level that qualifies as medium will vary from one model to another.

With the Dremel turned off, mount the glass sanding bit on the tapered side of it. The bits come in different grit sizes covering extra-fine, fine, medium, and coarse. When sanding and polishing glass, you have to start with a medium grit sanding bit on the glass and use an extra-fine grit to achieve the final polish. Turn On the Machine